Impact & hurricane windows
Laminated, impact-rated glass that meets Florida Building Code for our wind-borne debris region. No shutters to hang before a storm.
Quote impact windowsImpact-rated and energy-efficient windows, measured, permitted and installed by a licensed local crew. One visit gets you an exact written price, and we publish our ranges, which most companies here will not.
From one foggy pane to every opening in the house. Tell us what you have and we will tell you plainly what it needs.
Laminated, impact-rated glass that meets Florida Building Code for our wind-borne debris region. No shutters to hang before a storm.
Quote impact windowsSwap out drafty, stuck or fogged aluminum windows for insulated Low-E glass that keeps the Florida heat outside.
Replacing old aluminumImpact-rated sliders and patio doors that roll with one hand, lock tight and stop the salt-air corrosion.
Quote a doorWe work with HOA and association rules on color, tint and scheduling, and provide the paperwork your board asks for.
Condo & HOA windowsThe installers behind this site have been fitting windows and doors across the county since 1998, and the same local family has run the business since 2016.
More than 25 years of permits, inspections and Gulf Coast weather in this one county.
Every installer and service tech is on the company payroll, so the people in your home answer to us.
A certified PGT dealer that can also look after PGT warranty service, with other Florida-made lines to choose from.
State-certified as both a general contractor and a specialty contractor, each license active through 2028.
Not just swapping glass. The old frame comes out, the opening is prepared, the new unit is set plumb, anchored to code and sealed. Done badly it leaks in the first summer storm and nobody notices until the drywall stains.
Pinellas sits in Florida’s wind-borne debris region, so every replacement needs one or the other. This is the single biggest decision on the quote, and it is usually most of the price difference between two companies.
Laminated: two panes bonded to a clear interlayer. It stays in the opening when something hits it, and there is nothing to put up before a storm.
Cheaper up front, and a legitimate route. It means putting shutters up every time a storm turns this way. We price both side by side so the choice is yours.
Vinyl insulates better and costs less, and it is the common choice across St. Pete. Aluminum is slimmer and carries larger panes, which suits wide openings and water views.
Window replacement here needs a building permit and a final inspection, in a licensed contractor’s name. An unpermitted window surfaces when you sell, and insurers can decline a wind-mitigation credit without the closed permit. We file it and meet the inspector.
Impact glass is always on duty. Nothing to bolt up when a storm turns toward Tampa Bay.
Insulated Low-E glass blocks much of the sun’s heat, so rooms on the west side stop baking by 4 pm.
Florida law requires insurers to offer a windstorm mitigation discount. Pinellas homeowners who protect every opening commonly see $750–$1,600 a year off the premium. We hand you the product approval numbers and the closed permit, which is what the wind-mitigation inspector asks for.
Laminated glass cuts street noise and is far harder to break through than a single pane.
Most companies say “we pull the permit” and stop there. This is the detail from the City’s own Window & Door Residential Compliance Form, because it changes what you are buying.
St. Pete sits above the 140 mph line that defines Florida’s wind-borne debris region. Every opening has to be protected.
The City’s wording: new windows must have shutters or impact glass. Non-impact is allowed, but then shutters are mandatory.
Each window goes on the permit by manufacturer, model and Florida Product Approval number. Nowhere to swap in a cheaper unit.
Peel the stickers off on install day and the inspection fails. The permit then stays open against your address.
A quote that does not mention the permit is not a quote for the same job. An unpermitted window surfaces when you sell, and an open permit can hold up a closing. Permit cost runs about $7 per $1,000 of job value and is inside our price, not added later.
The same sequence on every job, from the first call to the day the permit closes.
Send the form or call. We set a time that suits you, evenings and Saturdays included.
We measure every opening, show you frame and glass options, and leave an exact written price.
Your windows are built to size while we pull the permit and clear any HOA approval.
Our crew installs, seals and cleans up, then we meet the city inspector so the permit closes.
Every style is available in impact or non-impact glass, vinyl or aluminum frames, and the colors your HOA allows.
The Florida standard. Bottom sash lifts.
Wide openings, easy one-hand glide.
Cranks open fully to catch the bay breeze.
Fixed glass for the view. Nothing to open.
Hinged at the top. Stays open in the rain.
Estimated ranges per window installed, checked against what other Pinellas companies quote. The free in-home measure turns these into one exact written figure.
Per window installed. The budget route, with shutters for storms.
Standard sizes from $900, large picture windows at the top. The common choice in Pinellas.
Slimmer frames, larger openings, coastal exposure.
Per door. Two- and three-panel, impact-rated.
Windows are priced per opening, so size, frame material and glass rating move the number more than anything else. We confirm the exact figure at the free measure, in writing, and it does not change afterwards.
One short visit. A written quote that does not change.
Hidden until a local partner signs. Then three of their real reviews show here with name, neighborhood and project. Never placeholder or invented reviews.
We install in every St. Petersburg neighborhood and the towns around it. If you are in Pinellas County, we come to you.
Old Northeast, Historic Kenwood, Crescent Heights and Roser Park carry extra review on anything that changes a street-facing elevation. We have the drawings and product data those applications need, and we build the review time into the schedule rather than discovering it halfway through.
Something else on your mind? Call (727) 604-6514 and ask a real person.
Leave your number and we will call to set up your free measure. Or reach us now at (727) 604-6514.